Hello!
Finally I have replaced new Intel Core Duo T7600 Processor to my Inspiron 6400 instead of T2300E.After rebooting the system I've got an message on the black screen saying following: ***Processor Microcode Update Failure***
The revision of processor in the system is not supported.
Strike F1 key to continue,F2 to run the setup utility."
So I have entered to setup mode and found that the system actually recognizes my new T7600.After leaving the setup Windows started working normally...But after restarting computer again the message appeared again.
Is that saying that my laptop is not using T7600 "complete" and experiencing some problems?..and what shell I do to prevent this message in the future and help my laptop to work properly?
Regards
Erni